CNC Operator
Department: Shop
Reports to: Production Manager
GENERAL PURPOSE OF JOB
Responsible for operating various edge machines.
ESSENTIAL DUTIES AND RESPONSIBILITIES
- Ability to read and understand fabrication drawings.
- Maintain an efficient, clean and organized work area.
- Ability to set up CNC and run edge work according to drawings.
- Follow all procedures put in place by management including but not limited to-tool dressing daily and calibrating tooling daily.
- Verify all proper pin locations after material has been loaded.
- If a quality issue is noticed, you must immediately remedy this concern. If you can’t, you need to communicate to the Production Manager.
- Perform the required maintenance on edge machines.
- Extremely detail orientated
- Other duties as assigned
WORK ENVIRONMENT
Indoors in a non-temperature-controlled environment. The typical noise level for this job is loud to very loud. Area requires steel toe boots, or rubber boots.
Position hours
Hours to be determined by Production Manager.
MATHEMATICAL SKILLS
Ability to add, subtract, multiply and divide in all units of measure, using whole numbers, common fractions and decimals. Ability to compute rate, ratio and percent and to draw and interpret bar graphs.
LANGUAGE SKILLS
Ability to read and comprehend simple instructions, short correspondence and memos. Ability to write simple correspondence. Ability to effectively present information in one-on-one and small group situations to customers, clients and other employees of the organization.
REASONING ABILITY
Ability to apply common sense understanding to carry out instructions furnished in written, oral or diagram form. Ability to deal with problems involving several concrete variables in standardized situations.
EDUCATION/EXPERIENCE
High school diploma or general education degree (GED); or three to six months’ related experience and or training; or equivalent combination of education and experience.
PHYSICAL DEMANDS
The position will required the following physical activities on a regular basis; Reaching, standing, walking, pushing, pulling, lifting, grasping, feeling, talking, hearing and handling.
The maximum amount of weight required to be lifted will be less than 100 pounds.
Apply for this position
Please complete the form below to apply for this position.